Vertical Mount Gun Rack For RZR 2013-2022 UTV’s Arms Bearer 2

Description: This rifle mount is specifically designed for RZR UTV’s. It is the only mount that has the following features on the marker today. They will never beat our price or quality of design. All other mounts only have two dash positioning adjustment holes we have 4 to allow for your specific needs. 1. Quick release mounting with the entire mount being removed w/o any part remaining in less than 60 seconds. No drilling or cutting of your RZR. Capability of the holders being loosened to swivel down out of the way and tightened in the down position with included wing nuts. Also if you have purchased the GPS -Phone holder it can also adjust to the mounts being down and continue to use it as normal. 2. The only true one motion exit with rifle in hand mount. Gently pull back from the mount and lift out with your exit of the cab. No re-entering to pull a rifle from the mount after you have already exited the cab. 3. Fully adjustable side to side holder adjustment and adjustable dash clearance . 4. Durability second to none. This mount has been fully field tested on the roughest trails & roads Montana has to offer with little if any rifle movement or mount deterioration . Other floor mounts are bolted threw plastic and thin steel and allow the weight of two rifle to constantly move side to side damaging the floor where mounted. 5. Our mount system does not interfere with roof or full door installation we don’t clamp or use the cab cage at all for our mount. 6. Vertical mounting in RZR UTV’s is our only design. Others mount horizontally, leaving the long rifles protruding out the side of the cage. This can lead to devastating results . Our mount system allows the long rifles & shotguns to vertical mount within the cage of a fully enclosed UTV leaving no part of the rifle to be hooked by limbs or brush & dislodged from their mount. 7. Our mount holder is 60% of the heights of a long rifle not allowing for sway . Other mounts if you look closely are shown with the rifles with collapsed stocks being under 50% of the vertical rifle height. And bolted threw seat parts that were only designed to hold the seat in the up position . With rifle weigh above the holders they constantly exert stress where they are mounted and always in time fail. Ours are frame mounted! Don’t be fooled by inferior designed clone mounts that look similar , they don’t use Quality Kolpin TM mounts or gel grips and attach in a position that hinders the dash functions ( switches & glove box see pic ) then visualize a 2” tall , 6” long plate protruding up from the tubing how you would ever reach or see your switches? Those mounts are double the money! The only mounts on the market with an available GPS -Phone w/USB powered mount accessory, & cup folding cup holder accessory Sold separately picture shown here is NOT included in the mount add. This accessory fits all Arms Bearer mounts and no others. Power to the mount is from the factory accessory plug in the dash directly behind the mount and the mount then has a USB port to keep your devise fully charged at all times. Folding cup holder is also an accessory others do not have for passenger convenience . When not in use it sits close to the dash out of the way. Availability is very limited . These mounts fit RZR 2012-2021 + w/receiver grab handle t-Bar square receiver Turn your UTV into a UHV (ultimate hunting vehicle) If your looking for our older mount for a 2007-2011 tubular mount we also have a few in stock same quality now revised since our 2015 model to include Kolpin TM mounts and the new gel grips same as our new models . This is a Arms Bearer 1. Contact us for details ! Now we have a 1000 General Arms Bearer 4 and mounts to test shortly same great products used on the RZR mount just designed for the Generals to current 2023.

Price: 99 USD

Location: Greenacres, Washington

End Time: 2024-11-15T22:20:11.000Z

Shipping Cost: 22 USD